Labelling the contours

[Note] : If you are new to this topic. Visit here to see all the topics in order.

 

Follow these steps:

1. Go to Terrrain > Contour Labels... > Group Interior

2. Set the Elevation Increment to minor contour interval used in drawing to label each contour line.
3. Check the Add multiple interior labels along each contours and set the value to 100 to label each contour in the spacing of 100m along it.
4. Once you hit Ok, look at the command line. Click at any two points (start point and end point) across the desired contours which are to be labelled.

5. After you click the end point the contours get labelled along the crossing line.

Remain attached for Smoothing, editing contours and many more.... .

Do comment any Queries.